Elettra-Sincrotrone Trieste S.C.p.A. website uses session cookies which are required for users to navigate appropriately and safely. Session cookies created by the Elettra-Sincrotrone Trieste S.C.p.A. website navigation do not affect users' privacy during their browsing experience on our website, as they do not entail processing their personal identification data. Session cookies are not permanently stored and indeed are cancelled when the connection to the Elettra-Sincrotrone Trieste S.C.p.A. website is terminated.
More info
OK

HowTo&Troubleshooting

How to select the required energy resolution

The BACH monochromator has both the entrance and the exit slit. These two elements are important in the determination of the energy resolution of the photon beam delivered by the monochromator. In order to check the resolution the user can utilize the ENERGY Resolution.VI or XPS Resolution.VI. In this VI it is necessary to set the grating in use, the energy of interest and the opening of the two slits (and the pass energy for XPS). The VI returns the theoretical (very close to the actual) resolution and the resolving power. These VIs are just calculators and can be used any time!

Then, using the MAIN PANEL.vi set the chosen opening of the ENTRANCE SLIT and EXIT SLIT. When you change the enrance slit opening the beamline will take ~30 minutes to stabilize, so you can observe some energy shifts..It would be better not changing the ENTRANCE SLIT very often unless necessary.

The Pass energy will be set by Scan XPS 2008.VI before XPS scans.
The STEP for XPS scans is usually set 1/3 or even a lille bit less than 1/3 of the total resolution. Only a finite number of steps can be choosen because they depend on the pass energy and the number of channels (16) of the MCP. The acquisition program will set the possible step closer to the value chosen by the user.

Last Updated on Thursday, 13 September 2018 12:57