Elettra-Sincrotrone Trieste S.C.p.A. website uses session cookies which are required for users to navigate appropriately and safely. Session cookies created by the Elettra-Sincrotrone Trieste S.C.p.A. website navigation do not affect users' privacy during their browsing experience on our website, as they do not entail processing their personal identification data. Session cookies are not permanently stored and indeed are cancelled when the connection to the Elettra-Sincrotrone Trieste S.C.p.A. website is terminated.
More info
OK

3D Pore-network quantitative analysis in deformed carbonate grainstones

3D Pore-network quantitative analysis in deformed carbonate grainstones

A 3D investigation of the pore network properties in deformed carbonate grainstones cropping out in Sicily and Abruzzo regions (Italy). . In this study, the pore network properties of suitable rock samples were studied by quantitative analysis of X-ray microtomographic images using both synchrotron and microfocus sources. 

 M. Zambrano et. al; Marine and Petroleum Geology 82 (2017) 251-264.

On the basis of the obtained results, inferences about the control of pore network properties on permeability were made for both host rock and deformation bands. In the host rocks, high values of connectivity seem to be associated with high values of permeability, whereas higher values of the specific surface area seem to correspond to lower permeability. Within the deformation bands, both porosity and pore connectivity are reduced except for local solution-enlarged stylolites and fractures (slip surfaces) preferentially connected parallel to the deformations bands.
The morphology and distribution of connected pores may have an impact on the permeability may explain variability on their permeability reported for the studied rocks.
In the fault zones, both connected porosity and pore connectivity decrease drastically due to the collapse or occlusion of pores by compaction, cataclasis or cementation. Therefore, the cemented and the cataclastic zones could be considered as local buffer zones or barriers to fluid flow. On the contrary, the connected pore-network, made of solution-enlarged stylolites and slip surfaces, is preferably connected and distributed parallel to the fault. Therefore, this configuration of conduits and local barriers may cause an anisotropy in the permeability within the fault zone.

Retrieve article

3D Pore-network quantitative analysis in deformed carbonate grainstones, M.Zambrano, E. Tondi, L. Mancini, F. Arzilli, G. Lanzafame,M. Materazzi, S. Torrieri, Marine and Petroleum geology,82 (2017) 251-264, DOI: 10.1016/j.marpetgeo.2017.02.001.

 

 

 

Last Updated on Wednesday, 28 November 2018 14:23