Elettra Systems

Insertion Devices

A range of insertion devices has been designed, built and installed in the storage ring starting from 1992. Most of them employ the permanent magnet technology...

Read more ...

Instrumentation

The main task of the Beam Instrumentation Laboratory (Laboratorio Elettronico Strumentazione, LEST) is the development of the ...
Read more ...

Magnets and Pulsed Magnets

alt

The Magnets and Pulsed Magnets Operative Unit is in charge ofeveloping and realizzation of pulsed power circuits needed for the injection...
Read more ...

Operation Group

The main mission of the Operation Group is to ensure, from the control room, the set-up and the supervision of the electron beam from the Booster up to the SR...
Read more ..

Radiation Protection

The main task of the Radiation Protection Group is to guarantee personnel safety against the harmful effects of ionising radiation...
Read more ...

 

Statistics

The Elettra's statistics is calculated in real time and displayed on the main page of the Electronic Logbook used in control room...
Read more ...


Vacuum

alt

The principal vacuum related activities regard both the Vacuum Laboratory  including the preparation, testing, installation and commissioning of new ....
Read more ...

Power Supply

alt

The Power Supplies Unit is responsible for all DC power converters for the magnets of the Injector and the Storage Ring of ELETTRA. The low frequency ...
Read more ...

RF

alt

In the storage ring the 500 MHz systems main task is to restore the electron beam losses due to the radiation, keeping stable the electron’s motion..
Read more ...

Preinjector

alt

The  100 MeV pre-injector linac has to provide single and multibunch operating modes.The machine is composed of a of a gun, a bunching section and...
Read more ...

Superconducting Third Harmonic Cavity

The main challenge of the third generation synchrotron light sources is to increase the beam lifetime. In the lowmedium energy machine...
Read more ...

Control systems

Control Systems

Control Systems mission is to support the facilities operations by providing reliable, high‑performance, user friendly and highly available ....
Read more ...

8th corrector

alt

Adding more correctors in Elettra is a necessary condition in order to control both position and angle in the bending magnet source points.
Read more ...


Last Updated on Monday, 26 November 2012 19:00